If you’re thinking about buying a heated towel rail to help keep your bathtub from getting too hot, don’t.
The idea is a little bizarre.
The problem is that the heating element is too small to be used for a full bathtub.
To help reduce the risk of damage, most people opt for the towel rail instead of a full tub.
This is not a great idea if you’re using the bathtub for something else.
But the heating rail is actually quite a good idea for a bathroom.
For one thing, the rail doesn’t have to be a full-length bathtub and is designed to be easily installed.
It can be attached to a shower curtain or a wall outlet and can be mounted on a counter or ceiling rail.
If you decide to install the rail, you can get it to fit inside the shower curtain with some modification.
The rail should be about 1-1/4 inches wide and about a foot deep, according to the manufacturer’s instructions.
It should have a small opening for the wire to pass through.
You’ll need to cut a hole in the center of the rail so the wire can pass through without touching anything else.
And you’ll want to be careful not to cut into the wall with the rail because it’s much harder to cut through than a bathtub wall.
In addition, the rails are made to fit flush against the wall and don’t have a separate door for drainage.
So you won’t have an opening on the outside of the shower wall to allow the water to escape.
You can still install a shower rail inside the tub, but that’s probably not a good choice because the rail can also be installed flush with the wall.
That means you’ll need a shower door or window to close off the rail.
And since you can’t fit the rail directly into the tub wall, you’ll probably need a separate window or door to allow water to drain from the rail before the rail gets installed.
You also won’t be able to remove the rail completely because the hose attachment will block the rail from being removed.
This can result in a mess if the rails don’t line up with the tub walls.
If that’s the case, you should probably just replace the rails with the other type of rail.
The other option is to install a full, tub-size tub wall and then use the rail to mount a water heater inside.
It’s not that hard, but it’s a little more work because you have to install two pipes and install the hose.
This might not be the best option for most people.
But for people who have a limited budget, it’s not too bad.
Just remember that it’s also possible to install an entire wall of heated towels on a single rail, which is the best choice for most.
So don’t be afraid to use the towel rails to help cool down your bath tub.
The downside is that you won (or should) pay extra for the extra rail and plumbing.
If it’s your first tub and you decide you want to use it for more than a few baths, you might want to consider using a full sized tub instead.